Reply To: Moving / Inserting Channels / changing Channel IP

Forums Forums GLD Forums GLD general discussions Moving / Inserting Channels / changing Channel IP Reply To: Moving / Inserting Channels / changing Channel IP

#37226
Profile photo of Pit Lenz
Pit Lenz
Participant

Chris has got it right!
But there are some details to consider:

-CopyPasting the mix the “select” button will copy and paste channel settings like EQ, Comp, Gate and Delay (only processing data, NOT PREAMP DATA).

-CopyPasting the “Mix” button will copy and paste assignments and levels of Aux, Grp and L/R mixes (BUT NOT “Pre/Post” SETTINGS!!!).

-CopyPasting Preamp&Trim (the oval green select button ONLY IN MIXER OVERVIEW, not in Processing screen) copies the input parameters (BUT NOT THE INPUT PATCH and NOT THE NAMES&COLORS!)

Channel Inserts can NOT be CopyPasted!

Now if you have 22 channels and want to put a new channel between -say- ch-10 and ch-11, you start to CopyPaste (“Sel” AND “Mix” AND “Preamp sel.” and “Input Names&Colors”) ch-22 to ch-23, then ch-21 to ch-22, 20 to 21 and so on until you have copied ch-11 to 12.
Ch-11 is doubled on 12 so you can now put a new setting and instrument on ch-11.
Then CopyPaste all Channel Names&colors.
Then check your input patch (but I assume you want to keep them).
And then check “Pre/Post” settings again. For most monitor mixes they should stay the sameā€¦

A little footwork to do, tricky sh*t but it works.
hopethathelpedā€¦