Reply To: dSnake problems

Forums Forums GLD Forums GLD troubleshooting dSnake problems Reply To: dSnake problems

#35992
Profile photo of BobWitte
BobWitte
Participant

I do understand where the A/D and D/A conversions take place. However, the power ground for the AR and the power ground of the GLD can still be an issue since the shield of the CAT5E cable (if shielded) will connect the two grounds (which could be 200 feet apart worst case)). Then it also depends on the power source for any instruments….. Highly unlikely this is an issue as it is minimized with the AR’s close to the stage. But transformer isolated DI’s are still needed to eliminate ground loops between the instrument and the AR’s. Again, RB stated HISS not Hum, so the PAD and gain setting are 99% more likely an issue. But IF the only change is truly the ethernet cable……