Reply To: dante to protools

Forums Forums GLD Forums GLD general discussions dante to protools Reply To: dante to protools

#35655
Profile photo of GCumbee
GCumbee
Participant

I have not seen this setup yet so can’t offer any help but in my previous studio work I owned a couple of large Pro Tools rigs. In the TDM/HD world there is an I/O setup screen when you have hardware interfaced. In my case I had one PT HD3 rig with 32in/out using Digi 192 interfaces on a MacPro. I would assume that with a Dante setup there is some sort of I/O setup page to route. I hope to get into that one of these days especially when I get my QU that is on backorder.

So anything learned here will be a help….