Reply To: Adding FX in monitors (aux)

Forums Forums GLD Forums GLD general discussions Adding FX in monitors (aux) Reply To: Adding FX in monitors (aux)

Profile photo of GCumbee

Group would not go to Main if you turn it off in the main…Unassign it.. Again I an working on this with the editor. Little hard to tell with no signal…Select MAIN MIX then go to Group and Unassign…That group should then work only on the IEM and Wedge mixes if what I am seeing is correct.

Only caveat to all this is we are creating a stereo group for the IEM(assuming you are using stereo IEMs). Your wedge is mono, so there is a bit of an issue there with what the wedge gets out of this. I have not looked through that and to getting that mono. Could affect your balance a little on that wedge. I have not ever done that for real.