Forums › Forums › GLD Forums › GLD general discussions › Adding FX in monitors (aux) › Reply To: Adding FX in monitors (aux)
2013/11/21 at 2:19 pm
#36222
I don’t have a console here to experiment but playing with the editor it seems you could do by just selecting up a wedge and a IEM and duplicate the mixes for each. Or setup a group and get a mix into it and then have it feed the IEM and wedge with the same mix. If I had a console setup I could run signals through it and see but in theory that should work. I have not done a lot of work with IEMs or Wedges yet on these. Mainly FOH and broadcast mixing. I am going today to a church that I have a 112 in for demo. If I have time I will try to simulate your request and get back to you…