Reply To: QU16 No signal from inputs

Forums Forums Qu Forums Qu troubleshooting QU16 No signal from inputs Reply To: QU16 No signal from inputs

Profile photo of Dick Rees
Dick Rees

You probably need to go through the Qu manual at the board and check all settings, levels and routing.

1. Are the inputs set to “local”?

2. Have you set the input gain for each channel/mic?

3. Are the channels assigned to the appropriate bus?

Select and Solo a channel to access the channel screen, speak into the mic and adjust the input gain until you see a good signal level. If you’re good there, check your assignments and routing, but verify signal present at the channel by select and solo.