Reply To: Option to change PAFL to a "solo in place" mode

Forums › Forums › GLD Forums › GLD feature suggestions › Option to change PAFL to a "solo in place" mode › Reply To: Option to change PAFL to a "solo in place" mode

2015/12/16 at 2:52 pm #52755
Profile photo of Nicola A&H
Nicola A&H
Keymaster

Hi Edi,

For studio use you could set an IEM strip on the Surface and patch the IEM output to your monitor speakers. This will give you fader control over your PAFL bus. Set Main LR to feed the PAFL bus when PAFL is not active (Mains to PAFL option in Setup / Audio / PAFL). You can also switch the Inputs from PFL to AFL to listen to the after fade & pan signal. This would effectively give you a Solo in Place solution.

Hope this helps.