Reply To: Effects Routing Question

[Dr. J]

Cornelius78 – you are the man! Thanks so much for taking the time to write this out! Very helpful & and I am catching on to the “assigning” method that A&H use for this board.

I am getting very close to replicating my external M-One unit. I am hearing a high pitch flutter in the A&H reverb which is distracting so I will dig thru the parameters to see if I can smooth it out or eliminate it.

While we are on the topic of effects chains and routing….. Do you have any suggestions where to place either Chorus or Doubler in this chain?

So far I have this for effects: Fx1 = Delay (spilling repeats into reverb input), Fx2= Reverb, Fx3= Chorus or Doubler (Can’t decide which I like better or if at all), Fx4= Snare Verb which I do like a lot. Also sounds good on Toms.

Thanks again!