Reply To: Connecting DBX AFS 2 to QU-16 connected to AB 168

Forums › Forums › Qu Forums › Qu general discussions › Connecting DBX AFS 2 to QU-16 connected to AB 168 › Reply To: Connecting DBX AFS 2 to QU-16 connected to AB 168

2015/10/27 at 8:40 pm #51721
Profile photo of [XAP]Bob
[XAP]Bob
Participant

Sorry – I was assuming you were running it against the main outputs rather…

You can run it on channels:
Turn off the routing of Channel X to the L&R mix, and make it POST fader to another Mix.
Take that mix ouptut through the DBX and back to another channel and route *that* to L&R

This makes the desk a little less intuitive, since you have two channels handling “the same” signal, but it should work.

You do end up eating alot of I/O doing this on a digital desk though…