Reply To: ilive and dante setup

Forums Forums iLive Forums iLive troubleshooting ilive and dante setup Reply To: ilive and dante setup

#51023
Profile photo of Nicola A&H
Nicola A&H
Keymaster

Hi Kyle,

In the Outputs screen, choose your Master rack in the drop-down menu at the top, then patch any required signal (e.g. MixRack Inputs 1-32) to Port B ACE (e.g. Port B ACE 1-32). Then select the Slave rack in the drop-down menu at the top, and patch the ACE channels from the Master to Port B Dante, e.g. ACE 1-32 to Port B Dante 1-32. Patch any Slave input (e.g. MixRack Inputs 1-32) to Port B Dante 33-64.

Hope this helps.

@ddff I think you are assuming they have a Dante card in each rack, but reading the original post this is an ACE-based Dual Rack system with Dante in the Slave rack only.