Reply To: Fader strips trembling

Forums › Forums › GLD Forums › GLD troubleshooting › Fader strips trembling › Reply To: Fader strips trembling

2015/09/28 at 11:58 am #50896
Profile photo of Edi
Edi
Participant

Hi Beartech,

The procedure is described on page 60 of the touchscreen reference guide where also is explained the necessity after firmware upgrade.
http://www.allen-heath.com/media/GLD-Touch-Screen-Reference-V1.5_1.pdf

Go to the setup -> utility menu to the calibration tab.

Select the fader calibration and follow the instructions on the screen.
Move the faders to the positions as described (be sure to move them to the printed labels on the board -> + 10dB is not the top end of the fader as minus infinite is not the lower end). Be also aware what the EQ zero line is (it’s also the point labeled on the board and not 0dB!!!)

Hope this helps and solves your issue.