Reply To: use equaliser to put low pass filter in place

Forums Forums Qu Forums Qu general discussions use equaliser to put low pass filter in place Reply To: use equaliser to put low pass filter in place

#48790
Profile photo of Andreas
Andreas
Moderator

so I’ve done some plots of actual Qu EQ responses, after checking out the plots you’re free to decide if PEQ/GEQ could be used as a proper LPF/HPF replacement. Cutoff always set to 1kHz for better readability.
Since only four attachments are allowed, this is split into four posts.

1-FlatResponse: simply verify my digital loopback is clean and properly leveled
2-1kHz-HPF: Response of the channel HPF
3-PEQ-1kHz-HPF: Shelving PEQ simulates HPF
4-PEQ-1kHz-LPF: Same for Low Pass

Attachments:
You must be logged in to view attached files.