Reply To: GLD80 + Dante Issue

Forums › Forums › GLD Forums › GLD troubleshooting › GLD80 + Dante Issue › Reply To: GLD80 + Dante Issue

2015/06/10 at 7:10 am #48569
Profile photo of Nicola A&H
Nicola A&H
Keymaster

Recommended clock settings for a single Dante system are as follows:
– GLD Audio Sync (Setup / Audio) set to Internal
– In Dante Controller, set the Dante card to be Preferred Master and ‘Slave to Ext Clock’, this will make the card sync from the GLD clock

DVS is always a slave device. Check the PT session is set to 48kHz.

Hope this helps.