Reply To: ST1 doesn't work after V1.7

Forums › Forums › Qu Forums › Qu troubleshooting › ST1 doesn't work after V1.7 › Reply To: ST1 doesn't work after V1.7

2015/04/10 at 8:42 am #46739
Profile photo of DavidCoDavidCo
Participant

Hi FoolProof,

Could you be experiencing this known issue? As there is no local preamp on stereo channels, I’d suggest checking FROM POWERUP whether dSNAKE phantom power is enabled on ST1. If it is, disable it, switch back to local, and power cycle the desk. You will also need to ensure no scenes contain dSNAKE phantom power etc.

If it is this issue at fault, V1.6 firmware should not experience this. If you don’t see any phantom power enabled on ST1, then it is unlikely to be this issue.

DC