Reply To: ST1 doesn't work after V1.7

Forums › Forums › Qu Forums › Qu troubleshooting › ST1 doesn't work after V1.7 › Reply To: ST1 doesn't work after V1.7

2015/04/09 at 11:17 pm #46730
Profile photo of Dick ReesDick Rees
Participant

I get no signal whatsoever on ST1 (keyboard), it seems this happened after upgrading to V1.7. I’ll try to downgrade to V1.6 and see what happens. Anyone else experienced this?

I get no usable information other than you’ve upgraded to 1.7.

Is there no signal showing on the meters when you PFL the St1 input? Where in the chain does the signal disappear? Are you sure you didn’t connect to the St2 inputs instead of St1?

If you’re showing input on the meter but no further, check the “assign”.

If channel is assigned to go further and you’ve double checked that it’s not assigned to a DCA or other control group, try loading a new scene and see if it works there.