Reply To: Pick-off point for AUX and ME1 monitor sends

[jcarter]

John, select the aux and go to the “routing” tab on the touchscreen. There are a number of pick-off points you can select between in the dropdown box in the upper right corner–everywhere from post-preamp to post-delay. Signal flow is preamp-trim-gate-EQ-compressor-delay, so it’s possible to do a post-EQ feed with no compression if that’s what you want.

For a given aux, you can select pre/post fade channel by channel, but the pre-fade pickoff point is the same for everything going into that aux.