Reply To: Pick-off point for AUX and ME1 monitor sends

Forums Forums GLD Forums GLD general discussions Pick-off point for AUX and ME1 monitor sends Reply To: Pick-off point for AUX and ME1 monitor sends

#46261
Profile photo of dcongdon
dcongdon
Participant

To the best of my knowledge, the AUX send pick point is fixed to Pre-fader (post delay) or Post-Fader. The only solution I have found for giving a vocalist a unique mix is to duplicate the channel somewhere else. Change the source in the preamp menu, unassign the duplicate channel from LR, then process to the musician’s preference. Duplicate channels will share preamp gain, but they have independent trim.

You can set ME-1s to pull straight off the socket, which gives them a dry signal and pre trim. Very handy if you need to adjust trim throughout the show and don’t want to impact IEMs. This would be a perfect setup if ME-1s had onboard EQ for each input. If your musicians want some processing, you can use Direct Outs to feed the ME-1s. You set the global Direct Out pick point from any channel’s Routing menu (pull up arrow).

Hope that helps.