Forums › Forums › Qu Forums › Qu general discussions › L&R&Sub › Reply To: L&R&Sub
2015/03/23 at 7:04 pm
#46108
dpdan
Participant
it sounds like the aux that is being used to feed your subwoofers is PRE fader.
Your input channels for the sub aux should all be set to POST, to make sure this is correct,
make sure you are viewing the Aux mix for subs by selecting the blue “MIX” button on the right-hand side of the console,
then on the left side of the console, push and hold the Pre Fade button, and tap each green SEL button so that the
green light is not lit on any of the channels.