Reply To: Dante – logic – no audio – help!

Forums Forums iLive Forums iLive troubleshooting Dante – logic – no audio – help! Reply To: Dante – logic – no audio – help!

#44158
Profile photo of Nicola A&H
Nicola A&H
Keymaster

To use Dante and Editor on the same network, set the Dante card to a static IP address compatible with the iLive network, for example 192.168.1.10 and reboot the card. This is done in Dante Controller. Set your laptop to another compatible static IP, for example 192.168.1.100. Assuming your iLive system is on the default factory IP addresses. Now if you bridge the iLive Network into the first port on the Dante card, and connect your laptop to the Primary port, you should be able to see both the MixRack and the Dante card.

Make sure you never run Dante multicast streams in this configuration, as that might saturate the Fast Ethernet iLive Network.

Hope this helps.