Reply To: anyway to assign softkeys 5 – 7 to mix outputs 5/6 7/8 9/10 ?

Forums Forums Qu Forums Qu general discussions anyway to assign softkeys 5 – 7 to mix outputs 5/6 7/8 9/10 ? Reply To: anyway to assign softkeys 5 – 7 to mix outputs 5/6 7/8 9/10 ?

#43218
Profile photo of
Anonymous

Thanks for the reply Bob.
THe QU works perfectly as designed.
mm yes I was a bit well… duh am I missing something here?
AFter doing lots of larger shows with the old GL 40 channel desks you develop a system with you desk and racks of EQues.
The QU nearly replaces that.
The are what appear to be 11 or 12 buttons/outputs (talking mono here)
The mix 1 through to 9/10 give 8 instant sends. mono!
at any given point if you want to mute you have to select the layer and then press mute.
Although you can assign & press mute 1-4.
I don’t think there is a way of assigning the remainder to the siftkeys to repeat this process.
Sure I can select the layer and then press mute.
I’m looking for less clicks (as one would say in editing)
I thought I may also be able to utilise sub groups “as output sends however these are relative to the top layer (FOH) which would be my 8th send or to keep things simple I would cal that “A” send to main vocalist.
The groups ALL unfortunately motor/move once through to the top layer position.

You know how it is.
11 pm at night.. major chane-over of bands. musicians all looking at you requesting this and that 3db up as they have had they pre dinner drinks and are pumping rearing to hammer you monitors so the cones pop out.
Gotta keep it all simple!

thank you
cheers
daveNZ