Reply To: Stereo Recording

Forums Forums Qu Forums Qu general discussions Stereo Recording Reply To: Stereo Recording

#43139
Profile photo of dpdan
dpdan
Participant

Hi Creator,
hit the “setup” button to the right of the touch screen,

output tab

hit the “Output Patch” tab, then hit the “USB Audio” tab just below the Output “Patch tab”
in the lower left-hand corner click on channel 17 and use the touch screen rotary knob to scroll through and choose “MTX 1 L”
then click on channel 18 and use the touch screen rotary knob to scroll through and choose “MTX 2R”…. hit “APPLY”

A tip…. after assigning a channel, you can hit the “Fn” key (lower left below the touch screen) and the next channel will automatically advance to the next available number. NICE!

Choose the LR mix button in the master section just above the master fader with the blue light,
then hit the “Routing” button to the right of the touch screen,

matrix button

hit the “Matrix Sends” tab,
make sure Mix LR is displayed (upper left) to show we are sending the LR to this matrix 1-2.
set the first button to “Pre”
the next button “On”
center the pan and set the level to 0 db.
0 db is a good place to start to get decent healthy level.

The Matrix (MTX 1-2) master fader is on the second “Layer” It is the second to last fader from the far right and it will be your recording level master.

matrix master

To start recording go to “Home”
choose the “Stereo” tab and you will see the small meters just to the left of the transport controls for record, playback and stop.

That should do it.