Reply To: Adjusting the amount of effect per channel in monitor mix

Forums Forums Qu Forums Qu general discussions Adjusting the amount of effect per channel in monitor mix Reply To: Adjusting the amount of effect per channel in monitor mix

#42288
Profile photo of [XAP]Bob
[XAP]Bob
Participant

The FX3 and 4 have a return, but they don’t have a mix available.

Page 44 of the manual (http://www.allen-heath.com/media/Qu-Mixer-User-Guide-AP9372_4.pdf) describes the three configurations possible:

Mix -> Return. Using the dedicated FX mixes OR two of the 10 “normal” mixes as the input – pure wet signal is returned on the FX return.

Channel -> Return. Instead of a mix this takes the Direct Out of the channel (being aware of the global direct out config) so it probably ideal for the OP. The pure wet signal is returned via the FX return.

Insert. Here the FX is patched inline with the channel, and the FX gains a wet/dry control to determine the FX level. The insert point (page 24) is Post preamp, pre EQ.

Given the Guitar requirement Channel-> Return looks a likely choice.
Although with a number of free mixes available you could use those instead.