Reply To: Create Mains subgroup for additional speakers

Forums Forums GLD Forums GLD general discussions Create Mains subgroup for additional speakers Reply To: Create Mains subgroup for additional speakers

#41624
Profile photo of GCumbee
GCumbee
Participant

You must have a matrix setup in your configuration first. Then drag a matrix into a bank. Preferably Bank 3 Layer D. Set level low to start till you adjust gain structure.

Go to I/O screen. If you are taking the feed from the stage box go to output side and setup a socket to be that matrix. Then the matrix you have done should show up there to go to your power amp or powered speakers. Adjust levels as needed.

At this point you don’t need to worry about Auxes. Just the matrix

Hope that helps.