Forums › Forums › iLive Forums › Archived iLive Discussions › Modifying dante outputs › 2941
2013/10/02 at 10:25 am
#35062
Hi jhalfast,
The iDR-48 will send up to 64 channels to its Port B Dante. These are patched using iLive Editor or a Surface connected to the iDR-48. MixPad does not give you access to the I/O patch.
I would suggest you check what you are sending out of the iDR-48 in the first place. In a FoH/Monitor split setup, you typically patch MixRack Inputs to Port B outputs, so the signals are not affected by digital trim or any processing. Also make sure the same MixRack Inputs are assigned to the iDR-48 channels you are tweaking on MixPad.
Hope this helps,
Nicola
A&H
