Forums › Forums › iLive Forums › Archived iLive Discussions › In which mix am I making a change? › 2664
2013/05/22 at 4:14 pm
#34023
I’m a bit new to iLive but as I’m working through setups on our board this topic is pretty fresh in my mind:
One option would be to put the sends on your rotary controls. That way the faders are always mains.
Another technique I found was to leave a Mains DCA available on every layer in one fader bank. In a pinch, just hit the main MIX key and then you know you’re mixing mains.
Our iLive is in a church setting and I have to continually drill “switch back to mains after touching monitors” into our operators heads. We’ve been on digital consoles for about 10 years and this has been my biggest training challenge for volunteer operators…
Mark
