Profile photo of Pit Lenz
Pit Lenz

You`re right, plevrier,
I followed your procedure and saw the same issue.
Funny thing: select Ch 45/46 and change the gain at the gain rotary under the strip or the iPad slider: you see the gain LEDs in the preamp section up left change as well (that`s OK).
But if you change Ch43’s gain with the rotary under the strip (Ch45/46 are still selected) , the strip’s gain changes, but not the corresponding red LED up left. So you can make the LEDs and the strip show a different gain setting for the same channel [:0]

@eotsskleet: at this setup channels 45/46 have inputs 1/2 and ch 43 is still on input 43.
You would be right with your response if they`d share the same input, but in this case they`re not…..