Profile photo of Leon BigEars A&H
Leon BigEars A&H


Originally posted by stephenwolf


Originally posted by steffenromeiss

press the desired mix and then hold PRE/POST Button and press select of that mix.
That should change the status for the whole mix.

Yes, I use that shortcut all the time, my point is that I have to do it every time I set a mono channel to stereo, or a stereo channel to mono, and that is annoying, especially if you are running 10 AUX outputs.
It has bit me a few times when I am only using 4 AUX for a show, and then the next week pull up a few more and those are still set to POST for a couple channels because they weren’t exposed on the board last week when I made a stereo change. I then start a sound check assuming everything is good and don’t find out till part way into it that a couple AUX with a couple channels are set POST because I didn’t see them last week and the board defaulted that way.

I would much rather be able to tell the console “hey, I am always wanting my AUX outputs to default to PRE when you reset a channel.”

You should save a scene Before you make any adjustments to Stereo Input configuration [all mixes have to be reset as you are building a new mixer]. Change the input stereos then recall the scene restoring all your mix attributes.

Leon A&H UK. Please do not adjust your set; normal service will be resumed as soon as possible!