Forums › Forums › iLive Forums › Archived iLive Discussions › reset pass to t112 › 1433
2012/08/30 at 9:54 am
#31255
Hi
We changed the non-modular mix racks to put the dip switches inside the Port B slot, on the right. This was because the iDR-16 PSU board mounts vertically behind the Main Board, blocking any access to rear-facing dip switches. There may have been a changeover period where a rear panel with the black plug was used together with a newer Main Board, which had the revised dip switch location.
If you look inside your Port B slot, you should see a set of 4 dip switches on the right hand side. These function in the same way as before.
Hope this helps.
– Jeff, A&H