2111

#31028
Profile photo of BobWitte
BobWitte
Participant

Stix, thanks for replying.

I hope that sitting on our family room floor under a card table with the GLD80 does not have a magnetic field of any significance nearby. We can roll out part of the cable to see if that helps, but I hope the design is robust enough to handle half of the cable rolled up in some way since we bought the long cable to handle various cable run situations…..

We will try to check the cable (after contacting the distributor).

quote:


Originally posted by Stix

Couple of suggestions:
1 -Test the cable for pin to pin continuity if you have a tester (I had one of the supplied A&H Cables have an intermittent single wire connection fault on one end)Fixed it by reterminating.

2 – Roll the cable out. Any cable in a coil near any magnetic field can be a problem.

Cheers

Richard Howey
Audio Dynamite Ltd
IDR48/IDR16/T112/R72/Mixpad,Tweak,
Dual M-Dante/DVS, 17″MBP/Logic 9/Custom Mackie Control


Bob