2090

#30902
Profile photo of Stix
Stix
Participant

quote:


Originally posted by Detonator

I thought I would put this here… When a system is booted up, the last used scene becomes active, but there is no indication of which scene name or number that it is…


You are not quite correct here Tim – when a system is booted the last desk “state” is recalled. The state it was when shut down. This might be the same as a scene but only if nothing has been changed since that scene was recalled. The mixer state is always a combination of the last recalled scene plus any active changes made since that recall. If you have made many many changes, done a mix config change etc then the current state will not resemble any scene until it is saved. That’s the reason there is no scene indication. An indication of the “Last recalled Scene” might be useful but may still be wildly different from the actual mixer “state”

Cheers

Richard Howey
Audio Dynamite Ltd
IDR48/IDR16/T112/R72/Mixpad,Tweak,
Dual M-Dante/DVS, 17″MBP/Logic 9/Custom Mackie Control