Profile photo of woutert


Originally posted by dburris

Is this only happening with on-line editors? I haven’t noticed this when saved onto a USB drive then copied to/from the editor.


It’s not so much about saving the show to disk. That works provided you have all the information. Where it goes wrong is when you’re saving all your scenes using one controller and then trying to save the whole show using another controller.
It doesn’t really matter if the latter one is a hardware controller or an editor, you will notice that scene names are not stored centrally in the MixRack so you won’t see any of them on the second controller.
This is most obvious with editors, since you can connect multiple, but it applies also to hardware controllers.

IDR32, R72, Dante, Mixpad
laptop, TP-Link TL-WR1043ND