2055

#30709
Profile photo of tspad1960
tspad1960
Participant

I am new to the iLive, but I had a similar situation when first evaluating the software.
When I first installed it, it did not seem to matter what I selected on the initial screen. I think what I had to do was to go into the scenes area and recall the surface and mixrack scenes to make the software remember the configuration. This is the same that you would do on a real system when creating a new show.

After this it seemed to remember what I had selected. If you dont have the scenes for the configurations, use shows to load a new show from a factory template.

tspad1960