1960

Forums › Forums › iLive Forums › Archived iLive Discussions › iLive with iDR8 and Dante › 1960

2012/04/02 at 3:04 pm #30313
Profile photo of Nicola A&HNicola A&H
Keymaster

quote:

Originally posted by co_yosuke

EMaster:iLive 80 Surface and iDR10 Mixrack via ACE card fitted in portA of each RAB2
ESlave:iLive 112 Surface and iDR10 Mixrack via ACE card fitted in portA of each RAB2

ELink for Master and Slave via ACE card fitted in portB of each RAB2

EMMO card fitted in portB open of RAB2 in iLive 80 Surface as Master is used for connection to iDR8 system .

Yes, this is possible, though some limitations apply to the MMO card when fitted in Port B of a Surface. Only the first iDR output port is available for example.

I’m assuming Master and Slave here refer to the clock Master and Slave units in a split FOH/Mon setup.

quote:

Originally posted by co_yosuke

EDante card fitted in portB open of RAB2 in iLive 112 Surface as Slave is used for connection to another Dante device.

This is not possible. The M-MMO card is the only option card supported in Port B of a modular Surface. You can still connect an xDR-16 expander to the Master MixRack Port B ACE (Link 2) and fit a Dante card in the expander Port B slot. This would enable 64ch Dante outputs and 16ch Dante inputs on your iLive system.

Hope this helps

Nicola
A&H