1950

#30091
Profile photo of Stealth
Stealth
Moderator

Hi Yosuke

quote:


Can this be right?


The Surface iLive-T80 connect to the Mixrack iDR-32 via ACE for audio and control.


yes this is correct

quote:


For Audio Clock Source, ES = IN fit PortB on iDR32 connect to the RAB2 ES PortB = OUT.


yes this is correct

quote:


For Control,ES CONTROL PORT fit Port B on iDR32 connect to
NETWORK Port open one of three ports on iDR RACK CPU of iDR10.



You ONLY need to connect the ES Control Port of the ES-V2 module in the RAB2 idr10 to your computer.
You do not need to connect anything to the ES CONTROL PORT of the module in the iDR32 as any control is done from the Master device.

You do not need to connect ES monitor at all to set up a simple Digital Mic Split with EtherSound.

All you should need to do to get this working is connect up the cables as i have said previously.
Set the audio clock source of the iLive80 and iDR10 to ‘internal’ – to do this go to Mixrack setup on the surface, Mixrack Pref, Audio sync = Internal
Then press the Port A/B Setup and press the ‘Master’ Button in the portB window and apply changes.
Now go to the iLive-T80 with iDR-32, set the audio clock source to sync from PortB – to do this go to Mixrack setup on the surface of the T80, Mixrack Pref, Audio sync = PortB
hen press the Port A/B Setup and press the ‘Master/Slave’ Button in the portB window and apply changes.

all you should need to do now is set your PortB Outputs of the iLive 80 with iDR10 to mixrack to ‘mixrack inputs’
and on the iLive-T80 with iDR-32 set all the input channel sources to be from ‘PortB ES’ – this can be done quicker by going to -Mixrack setup on the surface, Mixrack Pref,’Quick input Source Setup’.

Regards
Sam A&H