1875

#29214
Profile photo of frozenwaffles
frozenwaffles
Participant

hi everyone…ok i’ll just clarify this as maybe i have not been clear in an area….
At the moment, on the Meters page, the small LEDs that indicate GR for gate, comp and limit will flash according to what gain reduction could be taking place (based on the current threshhold settings). if its only a small amount the will flicker slightly, ifs its lots they will almost stay solid.
The problem with this is that they will indicate this gair reduction regardless of where the processing is IN or OUT.
All i want them to do is turn these LEDs off if the respective processing is not enabled.
currently the LEDs lead you to believe that there is compression going on, even though the processing is infact not IN.
i hope this clears it up…

Current stock:
2x T112, 2x R72, 2x iDR-48, 2x iDR-16, 2x xDR-16
4x Dante Cards, 3x ACE Cards