3

#29931
Profile photo of Stealth
Stealth
Moderator

Hi Guyharris

quote:


I would like the ability to lose the buses taken up by the Wedges and IEMs. I never, ever use this functionality, but I do run up against a lack of buses on the iDR32, when running 6 sets of IEMs from Aux and physical outputs.

Thanks!


If you go to Mixrack setup in the ‘mix config’ page you are able to remove Wedge and IEM from the mixer bus configuration.

You will still be able to assign the Wedge & IEM channels to a strip and have control over the output level though you just will not be able to do any processing on these channels.

Hope that helps

Regards
Sam A&H