Profile photo of sraymond


Originally posted by ddff_lv

I’ve got my iLive system back from rent with complaint that surface level indicators are not working. After some research I found out the Multicast was enabled on the iDR system. After disabling that indicators were working fine. Any idea why that is so?


Did anyone use a computer and editor to setup the system before use? I can’t say for sure as I don’t own a surface, but I wonder if someone connected to just the rack with the editor and set the rack to multicast with the surface disconnected that maybe the surface wouldn’t get changed to receive meter data via multitcast that the rack was sending. Someone from A&H would know if that could happen.


iDR 32
iDR D-Out
Lenova T61, M90, iPad2