Profile photo of frozenwaffles

i strongly aggree with the statement below….if you dont know that its in 20-20k mode, then it is very confusing!
Even within the bandwidth of each section there is a mismatch. I would prefer to see the leds track accurately within their intended range and then remain “pinned” at either end of their travel as you adjust past that point.
I must admit I had never noticed this myself(I don’t normally look at the leds), a visiting band engineer pointed it out last weekend.

Current stock:
T112, 2x R72, 2x iDR-48, 2x iDR-16
4x Dante Cards, 1x xDR-16