1731

#29408
Profile photo of peterderks2007
peterderks2007
Participant

Hi
In reply to Jeffrey V;

1.We only use auxes in pre fade mode, exept for FX and soundtracks,
as scruffyd says,only then these channels are best set in post-
fade.
2.It would defenately save time if all channels were pre fade.
In our configuration most channels are ,and only few in post-fade.
It’s faster to set a few channels from pre-fade to post-fade,than
almost every channel from post-fade to pre-fade(no rocket science).
3.I’sure hope R&D will read this topic and change the aux default
settings in standard pre-fade,this would save us a lot of time
alltogether because we use three different IDR Racks

This is a usefull topic,I hope everyone will read and reply on.

Thank you Jeff

Regards;
Peter

xxxx