1685

#28908
Profile photo of Stix
Stix
Participant

If you turn off your mac’s wifi, go to MBP network settings and manually set it to 192.168.1.X then you should be in the same address range.
Then run the Dante Virtual Soundcard software first – set your number of in/out channels, set sample rate to 48kHz and turn it on. Once you have done that you then run Dante controller and you should see both devices appear (mixrack and computer). You can then patch your connections. It is normal that you can’t patch a device to itself in Dante.

Hope that gets you going.

Cheers

Richard Howey
Audio Dynamite Ltd
IDR48/IDR16/T112/R72/Mixpad,Tweak,
Dual M-Dante/DVS, 17″MBP/Logic 9/Custom Mackie Control