1464

#27569
Profile photo of RayS
RayS
Participant

quote:


Originally posted by huffditty

RayS,

Thank you for the response, I am not a routing genius on this mixer yet. The first option you described is it possible to just perform this on the current config, which would be I.E. Mixrack Ch. 1>Surface channel 1>Processing strip>FOH Mix and just apply what is happening to the FOH to the Aviom send from channel one?

Or are you saying “unassign” channel one from the Avion/A-NET send and get my kick source from something else, like an aux send that would allow the processing to pass?

I have attached a screen shot from my offline mode, is this what you are talking about as far as direct output assignments? This just appears to be a global setting and not a per channel basis. Do you know if that is true or am I looking in the correct place?

The other option you gave me, I don’t know how that would apply. Because, we have the musicians “mix” thier own mix with the Aviom unit. We go use a couple Aux group to route to them for a “drum other” mix and some misc. Mic for public speaking. I am confused at how virtually coping channels would allow me to route them processed.

Sorry, just trying to figure it out.


in editor /setup/mixer prefs/ preferences…you will find your global direct out prefs…there you can choose to make these post or pre any processing in the strips…….see if this works before attempting the other suggestions….no need to repatch or unassign anything……

hope that helps

RayS

R-72/iDR32/iPS10