2011/01/17 at 9:29 pm
#27059
przemkoParticipant
hello
I had this issue too in my T112, and the problem is with the hardware. As my dealer explained, there is a resistor which is setting the limit value of the current going to motor-faders. Notice that when you press GEQ fader flip button, almost every fader changes its position. If the limit is set on too small value, faders doesn’t move and their current setting is copied to your EQ. Try to set fader levels to center position, similar to zeroed-EQ, and find the threshold above how many faders moved the issue occurs. In my case it was about 10.
best regards
Przemko
