2010/11/01 at 8:16 pm
#26689
mixiParticipant
Hi
I’m not shure about the firmware version of the board and rack, since I’m working offline currently, “simulating” a T112 and iDR32.
Herefore, I’m using iLive Editor 1.7.1.
If I open the editor, any Softkey can be set to control the delay time of any Fx-Engine.
But if I open the standard showfile copied out of the T112-Control-Surface, Tap-Functionality is limited to engine 4.
This behavior is the same for both the offline-Editor and the control surface.
Is there a possibility which I haven’t found yet to limit the use of the tap-function?
