Profile photo of James-pel

Sam, thanks for the response. It’s all of the above…I can set levels with the PL or the table PC but the audio, meters and faders all drop (while I’m watching the screen). The audio cables are fine. I’ve swapped them out several times and had the same results. I have not had any ACE warnings and I’m running the same firmware on all units. I’m guessing its a cat5 problem, but I’m not sure. I’m well below the max cable length of 100 meters and I’ve replaced the connectors once already with no luck. The cat5 cable was run carefully with no kinks, major twists, bends or breaks. Could it be the type or brand of cat5 connector?