Profile photo of dschmoldt

Thanks, Christian and Richard. That did it for me! – Dave


Start thinking from the channel, not from the input.

So go to channel 63/64, in the preamp section you can select the input source.

You now have inputs 57/58 and 63/64 fed by the same physical inputs. The channels are independent (expect gain, pad and phantom power, as that are digitally controlled analog parameters). You can route them differently and use different channel processing.

Bringing up inputs (in that case 57/58) to different faders does indeed not change the channel properties. You could have channels 57/58 all over the desk on every fader and all these faders would move when you move one of them. Think of a surface fader (and adjectant strip) as an alias to a channel.

Christian Tepfer
Hamburg, Germany