948

[Stealth]

Hi Mika

with regards to parrallel compression, you could source 2 input channels from the same sockets, so the same signal over 2 seperate input channels then mix the 2 seperate input channels together to create the same effect?

With regards to your other question, connecting editor and the surface loosing power.
To avoid Editor loosing connection if the surface was to loose power. Connect to the mixrack only, this way if the surface was to loose power editor will stay connected as a back-up surface.

Note. Make sure your virtual surface on Editor exactly matches your hardware surface to avoid any incompataility issues

Hope this helps
Sam A&H