923

#24688
Profile photo of Geep
Geep
Participant

I think the issue was, in fact, not recalling the correct surface when loading in a default scene. I did a recall last night, loaded the T112 scene, and was able to do that assignments, per Doug’s comment. Bob, indeed, became my auntie.

The inputs were not showing up on the touch screen in the output section, which oddly enough is where they are found in the editor. Doug’s explanation led me right to them and they assigned properly using the touchscreen on the surface

However, I still question why the editor program appears to ignore the c inputs. Perhaps I have told it that the surface was a T80 in error.

I’ll go back and have a closer look at that later this evening.

And once again, many thanks for the comments. This is a great desk, already turning heads in my area, where it is the only one to be seen that I know of.

geep

Geep