Forums › Forums › iLive Forums › Archived iLive Discussions › Synchronizing iLive to external clock signal › 898
2009/08/21 at 2:40 pm
#24579
StealthModerator
Hi Kristian,
1. Yes it is possible to fit RAB2 to any iLive surface, just not ilive T-Series surfaces.
2. Yes the RAB2 module has built in headphone amplifier, two card slots and optional DARS + Wordclock in/out connectors (BNC Connections)
NOTE: D.A.R.S + WordClock on the surface RAB2 will only work if you have a valid active audio link between Mixrack and surface.
D.A.R.S = Digital Audio Reference Signal – or AES11-2003 signal is AES3-formatted audio signal capable of being referenced, locked and distributed at the same audio frame rate of the iLive system 48KHz.
Hope this help
Sam A&H
