Forums › Forums › iLive Forums › Archived iLive Discussions › Aux pre/post source › 813
2009/04/13 at 4:32 pm
#24269
ryanlantzyParticipant
quote:
Originally posted by KB7981I believe to do this, you will select the ‘mix’ button under the aux you want to change. Then go to the source strip and click on the button at the top of the strip you labeled ‘post’ and it will change to ‘pre’. I hope thats what you were looking for.
Actually, that is not what I’m looking for. The Pre/Post setting per channel, per aux is only to set pre or post fader.
From the looks of the block diagram and after further investigation, the setting for pre/post EQ/gate/comp/limit are controlled globally by the direct out setting. Which is unfortunate.
