751

#24208
Profile photo of Lieven-Dewispelaere
Lieven-Dewispelaere
Participant

Dale,

There are two ways to asign a preamp to a input channel. the fast way is to open I/O in setup mode. That shows your inputs/outputs screen. than you simply click and hold an input from the I/O screen an drag it to the desired inputchannel. You can asign the same I/O to multiple input channels.If you click on an I/O, the already patched input channels wil lit up yellow. The second way is to press select on an input channel ( make sure you are in setup mode: none ) this will bring up the process select screen for that channel. Select preamp. there you can in source select assign ( or unassign) the input to your preamp . Here you can again assign multiple input channels tot the same preamp.

Hope this helps

Lieven